Hotpoint MN 212 IX HA Poradnik Użytkowania i Eksploatacji Pobierz pdf (Strona 5)

unpack and install the appliance.

After unpacking the appliance,

make sure that it has not been

damaged during transport. In the

event of problems, contact the

dealer or your nearest After-sales

Service.

The appliance must be

disconnected from the mains

before starting installation.

During installation, make sure the

appliance does not damage the

power cable.

Do not switch on the appliance

until installation is complete.

This appliance is intended to be

used built-in. Do not use it

freestanding.

Carry out all cabinet cutting

works before tting the

appliance in the furniture and

carefully remove all wood chips

and sawdust.

After installation, the bottom of

the appliance must no longer be

accessible.

Do not obstruct the minimum

gap between the worktop and

the upper edge of the oven.

Only remove the oven from its

polystyrene foam base at the

time of installation.

After unpacking the appliance,

make sure that the appliance

door closes properly.

In the event of problems, contact

the dealer or your nearest After-

sales Service.

ELECTRICAL WARNINGS

For installation to comply with

current safety regulations, the

appliance must be earthed and

tted with an all-pole disconnect

switch with a minimum gap of 3

mm between the contacts.

If the tted plug is not suitable

for your socket outlet, contact a

qualied technician.

The power cable must be long

enough to connect the

appliance, once tted in its

housing, to the mains power

supply. Do not pull the power

supply cable.

If the power cable is damaged,

replace with an identical one. The

power cable must only be

replaced by a qualied technician

in compliance with the

manufacturer instruction and

current safety regulations.

Contact an authorized After-Sales

Service.

For appliances with tted plug, if

the plug is not suitable for you

socket outlet, contact a qualied

technician.

Do not use extension leads,

multiple sockets or adapters.

Do not operate the appliance if it

has a damaged power cable or

plug, if it is not working properly,

or if it has been damaged or

dropped. Keep the cord away

from hot surfaces.

The electrical components must

not be accessible to the user after

installation.

Do not touch the appliance with

wet hands and do not operate it

when barefoot.

The rating plate is on the front

edge of the oven (visible when

the door is open).

In case of replacement of power

cable, use only following type(s):

H05 RR-F 3 x 1.5 mm2.

It must be possible to disconnect

the appliance from the mains by

unplugging it (if the plug is

accessible) or by using a multi-

pole switch that has been

installed in an accessible place

upstream of the socket in

compliance with national

electrical safety standards.

CLEANING AND CARE

Wear protective gloves for

cleaning and maintenance.

The appliance must be

disconnected from the mains

before performing maintenance

work.

Never use steam cleaning

equipment.

WARNING: It is dangerous for

anyone other than a qualied

person to carry out any service or

repair work that involves

removing the cover panels, as

these cover panels provide

protection against exposure to

microwave energy.

WARNING: Make sure that the

appliance is switched o before

replacing the lamp to avoid the

possibility of electric shock.

Failure to clean the oven regularly

may cause the surface to

deteriorate, which could have an

adverse eect on the service life

of the appliance and potentially

result in hazardous situations.

The oven should be cleaned

regularly and any food deposits

removed.

Make sure that the appliance has

cooled down before carrying out

any maintenance or cleaning.

Do not use harsh abrasive

cleaners or sharp metal scrapers

to clean the door glass since they

can scratch the surface, which

may result in shattering of the

glass.

1 2 3 4 5 6 7 8 9 10 ... 21 22

Komentarze do niniejszej Instrukcji

Brak uwag

Hotpoint MN 212 IX HA Poradnik Użytkowania i Eksploatacji Strona 5

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Kuchenki mikrofalowe Hotpoint MN 212 IX HA