Hotpoint DDP-700 Instrukcja Użytkownika Pobierz pdf (Strona 33)

MODEL NAME

DDP-700

USER GUIDE

PAGE

EXPANDING YOUR DECT SYSTEM

Pico cellular system

Your DDP-700 MINI DECT cordless phone can be configure as a pico-cellular system by adding more base placed

in different locations. This will extend your handset mobility. This application can be implemented in the office or

factory. If you configure your DECT system to operate in pico-cellular, you should see to it that the placement of

base unit will be optimized to cover the entire location where you intend to use your DDP-700 handset.

The following should be observed :

1.Register another base/s (another DDP-700 base or another DECT GAP compatible) to your DDP-700 hand

set.

2. Place these base in the location where you intend to operate your handset, place them to cover all area

without dead spot, this means that each base station is within the range of each other base. Please see

figure below :

3.Your DDP-700 however cannot establish a seamless handover (handover means the transfer of call-connec

tion from the range of location A to location B, please see figure above). The handover from location A to

be takes about 2 seconds or more. Thus, when you are on call progress on location D and moving to

location C, your DDP-700 will warn you (if

out of range warning

is set to on-see warning tone) of out of range

from location D. If you move closer to location C, your DDP-700 handset will lost connection and call will

be cut off. If you move further to location C, your DDP-700 handset will be connected to the base located

at C.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 57 58

Brak uwag

Hotpoint DDP-700 Instrukcja Użytkownika Strona 33